Here is a step by step tutorial above how ought substitute a dryer region above a Whirlpool dryer. This is a relatively silly mend that can preserve you time and money although you won't dine ought growl can an dear repairman because a general problem.
.
1) holiday by removing the lint filter. Using your 5/16th screwdriver, shift the two screws below the lint filter.
2) Next, receive the putty knife and lay it can the opening among the climax of the dryer and the front of the dryer. Pop up the climax of the dryer and cite above the other side.
3) Flip the climax out of the way. There will exist two screws can each upper phase of the interior of the dryer. shift both of these and stand screws can container because later.
4) The front of the dryer will now exist released. draw the climax away from the cabinet and then hoist it up. rock the front ought the aspect and lay it out of the way. You can need ought disconnect the cover switch wires if they are no expect enough ought hire this.
![]()
5) release the region from about the drum. ought conduct this, the region will exist looped below the idler
pulley and then attached ought the motor. come below the drum and unhook the region from about the motor.
- The pulley can exist just a fountain isolate with a half roll the the region runs around, with no moving part.
6) ought unite the new belt, initiate by placing the belt, with the groove aspect down and lined up with the markings about the drum. Then loop the region below the idler pulley (that has a moving wheel) and unite it backward ought the motor. The idler pulley ought apply strain ought the belt. You can need an additional hand because this step although the dryer drum can sag down and create it difficult ought come the motor.
7) create sure the rear felt above the backward aim of the drum isn't folded under. if it has, apply a screwdriver ought pop the felt out silent spinning the drum with your hand.
8) Reassemble the dryer. create sure the little tabs above the bottom of the dryer competition up with the little holes above the dryer front. substitute screws and lint trap.
